I have a 2001 b5.5 with the 1.8t AWM engine and I just recently replaced my vvt/cam chain tensioner, cam chain, and cam position sensor. A few months ago I replaced the timing belt, belt tensioner, and Water pump. I did the computer reset after and that cleared my CEL, the car fired almost instantly(which was an improvement from before the repair), turned it off so I could put a few things up for a test drive, came back and it didn’t want to start and the CEL came back. Eventually I got it to fire up and took it for the test drive and there was NO power until I was past 3k rpm and even then it was lacking. Got the codes read and it’s pulling a p0011 and a p0341. Any clues? I’m almost at wits end now after having spent so much time on it.