[rollininstyle2004]

Like the title says, i am going to buy some RAD locks for my 18'' Flik Articsc. I know that i need a 14x1.5 thread, but what legnth should i use??? Pure Motorsports has 26mm ball as the length and and seat. Are these the right size or do i need a different length???
TIA
-Jordan

 

[FLIP954RR]

try going to this website,or give them a call.
http://www.pure-motorsport.com/products/description.php/II=698/CA=50/PA=10
Good luck :thumbup:

 

[rollininstyle2004]

Yea, i was on pure motorsports website, but i wanted to make sure that they would be the stock VW/Audi size since they had like oettinger wheels as different and OZ wheels as different, but they dont carry Flik so they dont specify the size for them.

 

[blakwag]

First you gotta figure out if your wheels take a cone or ball seat (Look at the bolts that came with the wheels). Then you gotta measure the thread in mm. The above link has a measuring guide if you go to the bolts section. My old Flik AByss wheels took a cone seat, 14x1.5 @ 25mm.