Volkswagen Passat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,419 Posts
Discussion Starter · #1 ·
Got into a minor fender bender and need to replace the trunk lid and tail light assembly.

Trunk lid is pretty dinged up and the rear bumper has bulged out a little from the side.

Is there a DIY on trunk lid replacement and rear bumper removal?

Thanks in advance for your help.
 

·
Registered
Joined
·
1,419 Posts
Discussion Starter · #2 ·
I got a trunk lid from a junk yard. They tell me they would have to cut the harness since it goes all the way to the fusebox.

I have the option to detach the harness from my old trunk lid near the lock actuator and install this in the new lid. Or I could just cut my harness and join it to the wires on the new lid.

I would also have to replace the trunk lock on the new trunk lid.

I am interested to hear your suggestions.
 

·
Registered
Joined
·
1,419 Posts
Discussion Starter · #3 ·
Replaced the lock assembly on the replacement trunk and reattached the original wire harness thanks to the video below from DaOneEnOnly.


Kudos to DaOneEnOnly, it was easy after watching the excellent tutorial. Now its as good as new.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top