[ecell]

I need a definitive answer! I'm doing the motor, snub, & trans mounts and recently did the rear lower control arm on my 01.5 ATQ/DVZ, and I'm pretty sure these are what need to be replaced...

- motor mount: N-906-630-02 (bolt)
- trans mount: N-010-470-7 (bolt) + N-023-004-11 (nut), reusing 431-399-291 (stop)
- rear subframe: N-908-235-01 (bolt) -- yes, I'm getting an alignment after

Is this correct? All three are stretch bolts, right? Are there any other stretch bolts involved? Thanks!

 

[ecell]

#13 in above pic

#31, 7, and 4B in above pic (reusing #10)

Are any other bolts stretch bolts for this job?

 

[smac4th]

If i'm not mistaken the only bolts related to what you are doing that are stretch bolts are the ones for the subframe

 

[Electron Man]

^Was going to say the same thing. You really only need #13 and #31 (4? if entire subframe is dropped). Motor mounts are connected to mount brackets or the unibody using non-Torque-To-Yield bolts (i.e. these are reuseable, but most people use the new hardware supplied with the mounts).