Volkswagen Passat Forum banner

No start, no crank after trying to jump start

2801 Views 8 Replies 5 Participants Last post by  cchief22
Ok, I bought my old VW back from my ex wife, long story. Anyhow, when I got the car back it was showing the P0300 and P0301 codes for misfires but it did start after a jump to drive it up on the trailer. The battery was dead when I got it home and would not start with a jump, so I tried to jump it with one of the big battery chargers with the 200A start and now it wont do anything. I replaced the battery yesterday and still nothing, no crank no start. I checked all the fuses for the ignition but the owners manual is VERY vague. I am going to connect with my VagCom tonight and post the results, anywhere specific I should look at first?
1 - 2 of 9 Posts
check the two relays below to the lefy of dash, (relays) the two lowest and to the farthest left. they are easy to reach. To the lower left of steering column drivers glove box/cubby hole. Flips down ,bend plastic retainer up and box it swings down and out.
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.