Volkswagen Passat Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,203 Posts
ScottyJ, unless you are experiencing irregular tire wear after lowering; which is common with the Audi Quattro and VW 4 Motions, you might be better off using the control arm kit from ECSTuning instead of the expensive stainless steel one's from Custom Performance Products. The CPP Upper Control Arms allow you to obtain a wider camber/caster range than the OEM units, but they are very expensive. Just the upper control arms from CPP are more expensive than the entire 8 arm kit plus tie-rods from ECSTuning.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top