Volkswagen Passat Forum banner
1 - 1 of 1 Posts

53 Posts
Discussion Starter · #1 ·
I was wondering if there's any trick to reinstalling a used crash sensor where the position was previously throwing a code?

A new sensor went in on one side and I was able to clear the code without it coming back. On the other side I put in a second hand sensor but it is throwing the same code that the old one was. Probably a bad sensor but is it possible to reset the sensor or otherwise get the code to clear and stay clear other than by putting in a new sensor?

Seems like a dumb question, I know, but thought I'd ask.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.