Volkswagen Passat Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
390 Posts
Discussion Starter · #1 ·
I think this was asked and posted a long time ago?

Does anyone know how to change the bulbs from the bumper trim molding for the front yellow parking lamps and rear red bumper molding trim lamps??

_ Mil
 

·
Registered
Joined
·
1,047 Posts
Yes it was but here is HT

Push in on the front part of the light and then push it forward to slide the piece out. They can be a major PIA and in the back push in towards the back instead of front.
 

·
Registered
Joined
·
390 Posts
Discussion Starter · #4 ·
TX-B5.5 said:
Yes it was but here is HT

Push in on the front part of the light and then push it forward to slide the piece out. They can be a major PIA and in the back push in towards the back instead of front.
I can push it in but cant get it to slide forward to pop out??? Any helpful Tips out there?
 

·
4th Gear (Wax on Wax off)
Joined
·
4,974 Posts
You need to push it in a little further .. It was a PITA but it went ..
 

·
Registered
Joined
·
390 Posts
Discussion Starter · #6 ·
Jesstzn said:
You need to push it in a little further .. It was a PITA but it went ..
A PITA .. You got that right.!! :lol:

I got it though.. it was all good no wounds suffered! .. I'm refering to my baby! Not a scratch was made on the car! can't say so much as not hurting a finger before i found out how the lights come out but its worth it!
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top