Looking to purchase a set of Zuki 18x8 wheels. 5x112 with a +35mm offset. Will they fit. And can anyone tell me whats a good tire size to put on them. Looking for a wider look but i dont want and rubbing issues.
They should fit no problem in that setup. I ran a similar setup with a +37mm offset without any issues on a B5, so i would say yes. I ran a 225/40/18 on mine, no rubbing whatsoever. You can always use the following site, great for this type of questions. On top of the page you can input your current set and then input the set you want to use and it will show you if it does fit or not! Good luck on that.
So as the title says, the rear driver side tire has been losing air daily. I fill up the air to about 35 psi and by next morning, it is down to 10psi. I thought it was a small flat maybe so I went to get it patched. However, they told me the rear tires are wearing out so it'd be...
I'm considering purchasing a nice set of 17" Denver wheels to put on my 2003 Passat Wagon. I've seen a few photos of folks that have put Detroit wheels on their Passat, but I can't seem to find any with Denvers. Anyone have a pic they can post? Thanks!
Wondering if these will fit, they are 18"x8, 57.1 Center Bore with a +41 offset. I think they will, however what would be a reasonable size tire to run without throwing the speedo off too much, and preventing rubbing?
I've got a great set of OEM Madras I run in the good weather. I have the factory VW logo center caps, but would rather run a BBS logo. Does anyone know exactly what part I would look for or where to get them. Thanks in advance.