The cluch in my 2001 passat 2.8 keeps getting stuck to the floor an im unable to fine the bleed valve iv looked everywhere. i replaced everything
that gose along wit
with newparts... Help with picture if possible. Thanks
1st, comfirm that this continues even with the lower dash cover removed. It can get caught on it if it's not properly installed.
The bleeder valve is on the back of the slave cylinder, and above the axle heat shield on the driver's side. The back must be higher than the front to properly bleed it. I don't have a great pic, but this from a 2.7T, the hole in the center-left of the picture is where the slave cylinder would go.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Volkswagen Passat Forum
3M posts
158.8K members
Since 2002
Passatworld is a forum community dedicated to Volkswagen Passat owners and enthusiasts. Come join the discussion about mods, Quattro, Turbo Diesel, reviews and more!