Search Results for ‘torsion’

The original, unmolested (and never installed) Shine Racing SRS rear torsion bar stiffener I modeled the now fabled run of SnunkBars after. Personally — and I am naturally biased — the SnunkBar is a better get, but they are all gone. So I offer this gen-u-wine SRS rear sway with mounting...

SRS Bar and Test Pipe sold, Grill and suspension still available I sold my car before I had a chance to install some things that I had bought for it so I'm selling those too :thumbup: Keith Bloom SRS rear torsion beam stiffener with bolts and an A6 front strut bar that has been modified to fit...

Since they don;t seem to make them or have them in stock at the speed shops. I decided to ghetto them with urethane to fill up the voids. even the prothane insert do have some slack in them so filling them up with urethane and pressing the prothane after will fill them up nicely. bought a...

Original post deleted - was full of wrong info Took my car to the dealer, they tightened subframe bolts Front ride height was about 2" higher than back in wheelwell and car pulls Friend figured they accidentally tughtened down fronttorsion bar, but once we git under there this morning we find...

I can rent a 9.0 amp right angle electric drill from Home Depot and buy a titanium bit and some cutting oil; will that do the trick? I don't have a compressor, otherwise I'd think about going pneumatic. However, the pneumatic drills that I have seen at HD and Lowe's looked pretty wimpy...