Search Results for ‘terminal’

Getting these 3 codes in the Central Electrical module (scan below with only some short driving after code reset): Address 09: Cent. Elect. Labels: 3C0-937-049-23-H.lbl Control Module Part Number: 3C0 937 049 E HW: 3C0 937 049 E Component and/or Version: Bordnetz-SG H37 1002...

Save 25% on your Schwaben European Car Electrical Terminal Tool Kit Click HERE for your European Car Electrical Terminal Tool Kit

Could someone explain to me how the remove the terminals from the ECM harness connector? The white bar slides over, but the terminals don't want to come out. There doesn't seem to be access on both sides of the terminal for a removal tool. I did pry it out on my stunt harness and then all the...

Hey everyone, I'm almost ready to do phase one of my stereo upgrade (my old desk from previous vehicle and a new Alpine component set). Presently my B5 has the non Monsoon premium system (so factory 6 disc changer, factory premium headunit with cassette and the factory component speakers - def...

Hi, I have a 2.8 V6 4motion. Can anyone tell where I should clamp the negative clamp on my battery booster, space in the engine bay is limited. I've been clamping it to the negative battery post but I recently read this is dangerous as the battery has gasses that can explode :ambulance: if it...

The car died on the freeway a few weeks back and I had it towed to my work for the time being. It can idle for hours on end but when I tried to take it around the block it dies and wont restart unless I jumped it with another car. The ohm at the CCT sensor is 13.1, which is supposedly ok for...

Hey guys... 99 30v AHA How hard is it to change out the Positive Terminal Cable? I just popped my hood to do a visual inspection on my Timing Belt... and I noticed that the dressing was ripped open, and the copper was exposed. Now, can I cover that up with electrical tape for the time being...

Please help me to find a place to connect the power to my AEM Boost Gauge. I need switched +12V to stay ON during cranking as well. If power is iterrupted during cranking, the gauge resets itself to a false zero. So far terminal stud 75X under the dash does not comply. Also, what is the...

what is this "marshmallow" growing around my battery terminal and how to prevent it? what is this "marshmallow" growing around my battery what was the reason? How should I approach it for cleaning? and how to prevent it from coming back? thanks in advance!

Time to install my ham radio in my 2008 Passat. In my old 2005 B5 there was both a switched and unswitched heavy amp lug by the steering wheel column. Is it in roughly the same place in the B6? I don't want to start tearing the whole interior apart to find it if it can be avoided :lol:

Hey guys, I wonder is it possible to turn on (but not Engine) car while minus or negative terminal is disconnected? :confused: Just to turn my steering wheel 90-180 degrees

Which one is it? I know there's supposed to be a sticker which says which ones are 75x and which one is 30A but mine is missing for some reasong. 2000 B5 1.8T. Thanks!

What should I do? I've seen/read about using baking soda, but does that actually work? I just imagine it making a huge mess all over my engine compartment. I would be interested in just replacing the lead, because I'm not sure how much is left under the corrosion (a very interesting spikey...

Battery Drain - Fuse 14 CCM 600 mA draw for hours I recently got a new battery and it has died a couple of times. LCD clock doesn't even show. Battery down to 5 volts. I got it charged up to 12+v again and the car runs fine. Alternator tested OK. I did notice that when I connect the negative...

Hi, I just replace the battery in my wifes 2004 Passat 1.8t and I noticed on the positive terminal there is a second wire hanging off if it that doesnt seem to be connected to anything. Anyone know what this is?

The car: 2001.5 (B5.5) GLX Wagon w/ 1.8T, Tiptronic Transmission, and stock projector beam headlights (bulbs: H7, 55W, 12.8V). The question: What is the correct nominal voltage at the low-beam headlight terminals? In other words, if I pull the connector from the back side of the headlight...

Guys Anyone have one I could borrow for a little while (less than a week)? I need one and don't feel like going into the shop. New headlights are coming in and I have to retro my harnesses back to OEM (from us spec W8) :thumbup:

does any one know the thread about removing the terminal pin with home made tools i put in the pin and the wire decided to come out

I had some serious front end damage a few years ago and the harness connecting to the driver's side headlight assembly got a little munched. The munching was very close to the connector so it would have been hard to cut and resplice at the damage point, especially with the wires still in the...