I have a '98 B5 Passat Variant 110HP 1.9TDI Syncro. I use Vogtland 35/35 lowering springs right now, but after 2 years it's time to change back to normal height. :rolleyes:
I work sometimes with my friend, where we put 300+kgs of stuff in the back of the car, so I'm looking for some...
I drive a syncro 99 B5 with the V6 engine.
10000km ago, I changed the timing belt, serviced the engine (new NGK BRK6E plugs and wires) and changed a faulty oxygen sensor with a generic Bosch sensor.
On my drive home on thursday evening, the car started running badly, with a...
Just dropping in to say hello. I picked up a new daily driver since I live in Alberta, Canada, it had to be AWD. So if found a lovely 91 passat wagon in tornado red, that has a bunch of great stuff done to it. It was originally a FWD 16v car. But the previous owner to the person i purchased it...
I am converting my Mk2 Jetta 16V to be a Syncro. I purchased the complete drive-train from a Canadian car, it is a 1993 Passat G60 Syncro. I've been doing research on things to get this done. I understand the body and sheet metal modifications that will need to be done as well as the fuel tank...
I wrecked the clutch last week and need to install a new one. Question is, does the engine have to come out to do this job, or is it possible to leave the engine in?
The car is a 1999 Passat 1.9TDI (AFN) Syncro.
Hi! i have this low budget projekt.
its an good old 32b gt syncro with an 10v turbo engine from a urquattro.
i was thinking about how it would work to remove the front driveshafts, and weld the middle diferential?
i know some does it on early Audi s2 and s4 and so on, and seems it last a while...
Bjorn Johnsen, 25 years old and works as a personal service mechanic in Ostersund, Sweden. Live with my fiancée and our little Rottweiler Male Nixon.
* The car was purchased May 11, 2009
Power / Torque (Short facts)
* 193 hp / 280 Nm
Engine, gearbox and exhaust system
* 2.8-liter V6...
Wondering if anyone out there could help?
1998 2.8 syncro 170000 mile but a cracking car runs great most of the time but when i fuel her up the tickover wonders between 250-700 causing it to stall at times.
After about 50-80 miles she is fine and will be fine until i fuel up again? baffling me...
Here goes nothing!!! I am starting my TD conversion project. I currently have a 1992 Passat G60 Syncro that is not running and a 93' Passat 1.9TD GL at home. I plan on pulling the 1.9TD from the 93' and installing it into the 92' and selling the G60 with wiring when all is done. I will use...
Happened to discover AFTER I bought the vehicle that no performance parts really exist for the V6.
There is the PES G2 eaton charger. However, I could never justify spending 4k on 100bhp.
Then the engine conversion with an S4 2.7TT, lot of work and around same price as charger IF the engine...
...Now i know i am going to catch some crap from the purist of the Syncro, but does anyone knows if there is a lowering spring set or coil that would work on my 1987 VW Quantum Syncro wagon?
I heard that the Audi 5000 springs would fit on it but i do not know if it would lower it at all or...
I have a VW Passat Variant Syncro 1.8, that's been on the street since november 98. It has a towing hook, otherwise it's just non modified.
I've noticed that when I load the trunk, just mildly, it will sink in the rear. Sink too far for my taste.
I now also have a pop up camping trailer...
Right now i am refineing a Passat V6 Syncro 99 years model. Here is some pictures. The car will be seen at its first time at a show i Malmo (Sweden) at the 16th April to 19th April.
Before I had done anything:
29th october, The project starts.
test of the frontbumper and headlights...