hey guys, im trying to get money out of my car so i can get a new one.... heres the specs for the wheels
rotiform nue monoblocks
et 30 all around
yokohama s drives 195/45/17 all around
setup has 5k miles on it
looking to get $1300 obo/negotiable wheels...
I have just installed H&R CUP KIT VW PASSAT (50mm front, 40mm rear) and im fully pleased with the results, aesthetical and driving also!! I would recommend this Kit to anyone.
My doubts now focus on rims: 18" or 19" ... dilema!
I have both offers of BLQ Rotiform Rims but i doubt between...
(4) 19x8.5 ET35 Rotiform BLQ in machine polished finish. Nankang NS2 225/35/19 tires all around, rears have bad camber wear on the insides and should be replaced soon. The wheels are not perfect but they are in good condition with all 4 centercaps. There is slight curb rash on ps rear, normal...
Just looking to see if there's any interest, I'm always looking to change it up.Bought the wheels locally, I'd say they're about an 8 out of 10, couple nicks/imperfections here and there that come with driving a car with them daily. Tires are nankang ns-II's with less than 1k miles on them...
wheels arnt even a year old. ran them from april to september. one wheel is curbed but can be sanded out and one tire is junk. other three wheels and tires are mint. 18x8.5 5x112 et 35 nankang 205/40/18. all wheels are straight, no bends and were balanced in august before H2oi. 1000$ no...
I was think about getting some Rotiform forged 3 piece concave-BLQ's but since the width and offset is customer specified i was wondering how wide i can go and what offset i should go for
i have a 2003 FWD V6