Search Results for ‘ready’

So, I've decided to pull the trigger and purchase the Frankenturbo F4H-L. After much research I still have a few questions... My man Oliver, over at SpeedTuningUSA in MD, is hooking me up with a fully custom tune for $275. I, being the 18 year old that I am, of course want the maximum power...

Approaching fast in yet another winter season, and i want to take some time to make sure the car top to bottom will be in the best state possible to avoid corrosion and rust and keep it in optimal condition. Well to start Coilovers- i dont see a need to put the stock suspension back on for a...

02 passat 1.8 T auto - looked over the info base post by Snake and was confused over the fill plug location - 17mm hex. The blauparts pics show a side filler hole and I was looking all over for it - turns out its on the bottom of the pan on my Passat which I wouldn't have thought (the side...

so i finally had time to install my gt28 along with my fmic, manifold, high flow cat, and injectors (after its been staring at me in my room for the last few weeks) and i am ready to tune. i am doing my own tuning with the help of my buddy and his dino and was wondering what would be a save...

Well my h*e of a girlfriend is getting ready to hit 100K. Ive completed most of preventitive maintence since I picked the car up. My question is there anythings youd recommend. I think I have slightly lower oil pressure not 100% on this one though, I havent cleaned the pan or pump. I have engine...

A while back I noticed the outer casing of one of my oil cooler lines was peeling away. I now have the two new lines ready to install. Do I need to drain the coolant or is there a trick to doing it with minimal coolant loss?

In preparation for the "Gold Rush Rally 2010", I've decided to get some static-cling decals for SNKVNNM. I just received a box full of some "vintage" decals and started on apply the passenger side. I should be getting the Gold Rush rally vinyl for the rear fenders. I do have a set of meatballs...

***UPDATES*** new part, can't belive I got it and for FREE!!! can you guess what it is? still in the works, s4 clutch conversion, JHM SS and solid linkage Installed: 034 control arm kit 034 snub // tranny & motor mounts O-bar rear Sway Bar S4 front sway bar (29mm hollow just like b5...

for summer! looked like these before paint going on the wagon

RS6 Plus - Article here

Hi, I have a 2001 B5.5 wagon with the 1.8t engine. I'm currently at about 140k miles. Normally, when I have had a car that gets to that age/mileage, I start looking to replace it. However... I haven't liked a car as much as like this one! So, in lieu of purchasing another car, I'm...

Electric carmaker Tesla preparing IPO: sources

I was asked to do a little photo shoot this morning, this afternoon i started dismantling her for the upcoming winter votex is off coils getting raised in a day or two picking up my winter boots from paint in a few days but some photos before the snow comes...