Search Results for ‘pc16’

Even so everything is no 'back to Giac stock' (correct injectors, correct MAF, AFPR set to 40 psi (2.8 bar) according to ECS inline gauge), the car is just not running good. It feels as if too rich (when feathering to higher rpm and boost levels, the car actually runs like a bat out of hell)...

I'm trying to figure out my stumble at wot. At idle my pc16 is a 35. Wot 3rd gear is between 60-65. It stumbles at wot. If i feather it it doesnt. Does anyone know.what this is disposed to run at? I have a 3 bar fpr at the moment. I was testing to see if.my fuel pump was shot. I replaced...

As the title says: Want to buy a GIAC PC16 ECU and an EVOMS Cold Air Intake :rolleyes: Thanks! (Moderator: Please move to WTB/WTT section)

as the title states im looking for a G.I.A.C pc16 file ecu. ecu ends with 557p and preferably coded for a manual trans thanks!

This is all stuff coming off my car because I'm upgrading to a GT2871r setup. Shipping is not included. Shipping will be whatever shipping costs. SOLD: genuine Borg Warner K04-15 from 034 Motorsports. SOLD: Cast, high flow exhaust manifold for longitudinal 1.8t engine with K03, K04 or Hybrid...

Any one running the united motorports tune for aeb k04 ?I have pc16 but I'm maxing out my maf from 5000 up, the unitedotorsports gets tuned to a bigger maf, AND can do k04/ ft/ bt.. and there's a local united motor dealer that can put it on the dyno also to check how its running. I know...

So as shown in my previous post with the dyno, I'm hitting 11.5a/f at 3400rpm, then from then on going in to the 9s and back to 11.7 later on around 5700. I need to try to fix the dip to the 9s, I cant lower the fpr because then I would be lean up top. Has any one used a rpm based boost...

Any one have info on the giac flashloader? And info about the pc16 100 octane file? I'm lookin to take my car to 1/4 mile track and want the best I can get to beat my buddies 14 second cobalt ss. Any one take theirs or have an estimate of what to expect even with the regular 93 octane pc 16? And...

Finally getting the Giac pc16 tune this Friday!!! Just wondering how long it took everyone's install and how they like it, just incase I need to back out and get the uni chip. HURRY UP FRIDAY!!!!!

SOLD ***1999 Silver 1.8 Tip Wagon Partout (Utah)***K04, GIAC PC16, Tip Chip, etc.... SOLD ***1999 Passat Silver 1.8 Tip Wagon Partout *****Entire car being parted out*****(Utah) This has been a great car and I feel almost guilty parting it out but it just make more sense than selling...

Just wondering if RC 310cc injectors would work for the GIAC PC-16 software. Also, where would I get a cheap but reliable downpipe for the pc16?

The K04 is ready to go in. Currently sourcing the Giac PC16, matching injectors, AFPR (for 2.8 bar). Using gutted downpipe (later 3" DP) and delete the main cat. How about the intercooler? Can I wait with it and run the stock for now? I have the same setup on my 1998 A4, put a Godspeed 20x6x2.75...

Going from this.......[K03 + GIAC 1.1 Bar 93 Octane] (i think that is Mike aka V4Vangelder face on his phone via Waterfest 07) To this......[K04 + GIAC PC-16]

I am ready to install a K04. From reading up, I think the GIAC PC16 file/tune would serve my purpose best. I am now trying to locate someone who can either install the chip/file into my (trained, spare, stock) ECU, or can send the chip and help me do it. GIAC PC16 or similar K04 tune. Also...

How many guys that are running a K04 with the GIAC PC_16 benefitted by using an adjustable FPR running 2.7-2.8 bar rather then the 3 bar FPR. I know there are some posts but I am looking at purchasing an AFPR to dial down the pressure as i think im running too rich. Looking at the back of my...

I cant find any 100% info on this? Whats power is this good for?

I intstalled the PC16 upgrade with a k04,310cc injectors,4bar fpr,fmic,n75j valve and also added a testpipe.It is spiking as high as 25psi,and if cruising at 2500rpm and mash it it shutters and falls on its face.My apr chipped aeb will smoke this thing.Any feedback would be great,thank you in...

Couple of my friends cars; trans am 00 ls1 a/t 14.2 little under 100mph My other buddy geo prizm 1.6 had 75 shot ran at the track with 50 on her mid- high 14s, now he's putting a turbo with e-85 on it,:lol: but the t/a I want to take out is this going to be enough? I'm going to find stick...