Volkswagen Passat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-17 of 17 Results
  1. Volkswagen Passat B5 Discussion
    My 02 1.8T has started stumbling occasionally while driving. Just a tiny second of rough running once or twice a day. Other than that, the car is running great. It doesn't always illuminate the CEL. First time I scanned the computer I got a P0011, and the next time a P0012. First scan...
  2. B5 Garage
    01 b5.5 1.8t. Backstory: had a P0340-Camshaft position A sensor circuit 1 fixed that with a good used oem sensor but then I got P0012 figured it was my CCT(had bad rattle on cold start) replaced that with a cheap one ?‍♂️ Did not fix issue, I as well replaced my pick up tube (didn’t need it)...
  3. Volkswagen Passat B5 Discussion
    Getting both on 01 AWM. Am I looking at replacing the CCT again? Car has 235k on it, with about 55k on CCT.
  4. Volkswagen Passat B5 Discussion
    I've recently been getting a recurring CEL for coil #4 which isn't moving with the coil (swapped coil with cylinder 3) but the CEL is always for cylinder 4. I pulled the rubber boot back and didn't see anything that jumped out so was thinking of just replacing the entire harness for that...
  5. Volkswagen Passat B5 Discussion
    Vickie is being a real bitch. :banghead: She's a 2001 VW Passat 1.8t AUG manuel who is throwing out codes p0012 and p0010. This isn't the first time. Last June I began randomly losing power as I drove... it progressively got worse (one a week, to daily) until finally the car would not start at...
  6. Volkswagen Passat B5 Discussion
    Recently failed emissions due to p0411. Changed combi valve and saip then cleared code. 4 days later the cel came back on and I figured it was because the parts I got were from a junkyard. After scanning turns out it's showing p0012. I don't think the repair could be related to this code as I...
  7. B5 Garage
    Engine idles a bit rough. I get random codes P0340 and P0012. Immediate thought was bad cam sensor so I replaced that. Still getting the codes and the rough idle. As soon as you give it the slightest amount of throttle it runs like a champ. Codes only pop at idle. Thoughts? Thanks.
  8. Volkswagen Passat B5 Discussion
    I have this code that comes and goes. I reset it and comes back after 50-80 miles. Anyone had to deal with this and what's usually triggering it. I heard it's the tensioner when it comes to cold starts. My 2003 2.8 V6 GLX has 115 miles on it and works ok. Timing belt was changed all should be...
  9. B5 Garage
    108k miles or so; still using original coils; cam adjuster replaced under warranty at roughly 80k miles; timing belt and related parts replaced at about 90k while I had half the work done for unrelated reasons. Driving home last night when the engine began to misfire, couldn't exceed 40mph or...
  10. Volkswagen Passat B5 Discussion
    A little back note first. I just replaced my A/C compressor last week. I also found out I have a small leak in the bottom of my oil pan from hitting a pot hole. I went to the oil change location and then filled my Passat 1.8T 2002 with 10w40 Castrol Synthetic oil since it was low. Well since...
  11. Volkswagen Passat B5 Discussion
    Great forum, I've learned alot already, but now it's time to ask, thanks in advance for reading. I'm no VW expert but a good mechanic, working on my GF's car a 2002 Passat 1.8t (AWM) with 140k and need some advice. Car has a few issues, sludge in the pickup, already taken car of and helped...
  12. B5 Garage
    First thanks for taking a look at my problem. So I just bought a passat, it's a 2004 b5.5 and it had a front end colision. The body and paint are good but it has some codes on. One is for a evap leak... easy. One is for a turbo low boost... easy enough. But the other is this P0012 code, which is...
  13. B5 Garage
    My car is a 1.8T 2002 Passat wagon and I have an annoying engine light that I can't get rid of. P0012 "A" camshaft over retard. I've spent over a $1000 trying to correct this issue with no luck. The car runs great the only problem I notice is that it runs rough on cold starts. It almost feels...
  14. B5 Garage
    Retrieved the P0011 code on my 01 AWM a few weeks ago. I ordered up and replaced the chain tensioner as I was needing to do a VC gasket anyways. The car runs smoother than it ever has since I've owned it after the change but now I've gotten a P0011 code yesterday morning and a P0012 code this...
  15. Volkswagen Passat B5 Discussion
    OK..Help needed here...seems like this is either an easy question or conversley no one knows... BUT none the less - no smog ticket without fixed... Replaced head, replaced CCTensioner...all seems well..runs great.. but throws P0012 (16396 KWP1281) intake cam not reaching setpoint...
  16. B5 Garage
    Alright, so i replace my hammering combi valve this weekend. :thumbup: Cleared the cel and damnit within 20 miles if get another cel this time P0012 :banghead: Camshaft position timing over retarded bank 1. I know this problem arose during my repair of the combi because my power went down and my...
  17. Volkswagen Passat B5 Discussion
    My CEL came on, so Iwent to an autozone and that's the code they got. It said something about "cam shaft actuator timing over-retard" Is this something covered by the powertrain warranty? thanks in advance!
1-17 of 17 Results
Top