Search Results for ‘p0010’

Vickie is being a real bitch. :banghead: She's a 2001 VW Passat 1.8t AUG manuel who is throwing out codes p0012 and p0010. This isn't the first time. Last June I began randomly losing power as I drove... it progressively got worse (one a week, to daily) until finally the car would not start at...

Hi guys, I did some research on this issue and still need some help. I get the p0010 camshaft position actuator a bank 1, circuit malfunction. So, I figured it may be an 'electrical issue' of some sort. I changed the camshaft position sensor and still doesn't work. I read to test the solenoid...

My MY07 2.0T Wagon has died! I received an MIL. Checked it out and it was P0010 and P0243. It almost immediately went off. The car was running fine and I set out to check the cam position actuator. I never got to it. My wife drove home from work and said the light came on again as she pulled in...

Probably due to the pressure in the PCV system this P0010 error came on. My smog was due so I replaced the PCV, the PRV, and the suction jet pump. I checked the resistance of the solenoid of the cam chain tensioner and it was below the required OHMS of resistance. Luckily, I still had the...

Gents, and/or Ladies, I have a 2001 B 5.5 1.8T AWM Passat that won't start. When we purchased it about 2 months ago it had 106,000 miles on it and ran good, but needed to have the CCT replaced, which I did. NOT an easy job, but afterwards it ran great !!! Then the Suction Pump Purge Valve...

01 Passat Wagon 2wd 1.8T AUG engine. Believe me I have searched this forum and others for help on this. Vehicle is throwing the P0010 code for the camshaft tensioner bank 1 blah blah. Test on tensioner came back at 12.7 ohms. Everything I've read says it's supposed to be between 10-18 so I'm...

A little back note first. I just replaced my A/C compressor last week. I also found out I have a small leak in the bottom of my oil pan from hitting a pot hole. I went to the oil change location and then filled my Passat 1.8T 2002 with 10w40 Castrol Synthetic oil since it was low. Well since...

2002 1.8 T with P0010 code. I changed the camshaft position sensor and also the hydraulic camshaft timing adjustor but issue remains. Please help

Hello Everyone, I need your help as I am having a really hard time correcting this issue. It started out back in October when I got this code for the first time. I pulled the code and checked out the forums here and most you were recommending on replacing the camshaft position sensor. I replaced...

Hello, First off want to thank everyone on this board. Working on a friends 1.8T Passat and with searches was able to find detailed information on timing belt / water pump replacement and completed the job a few months ago. The problem now is a check engine light and when running the codes get...

ok i have a 2001 passat 1.8 my car quit on my coming from work. so a friend had the computer you hook-up to the car...came back p0010 cam shaft bank A so i get this fixed be him he good and cheap fit in my buget.. 3 days go by my car wont start aging. he comes out says to me it the same thing...

As stated in thread title, I was blessed with a CEL yesterday evening. The corresponding code is P0010, with a description of "Camshaft Position Actuator ABank-1 Circuit Malfuntion." I recently changed my timing belt. Could this be related? Did I mess up the sensor when I was disassembling the...