Search Results for ‘orings’

This deserved a separate thread because AndreasPassat and I are discussing an issue that is puzzling. He's convinced that there are two orings, and I only have one. I have one on the old one I removed, and only one came with the new one I'm about to install. It mounts on the outside of the...

Hi all. I'm hoping I can get a part number validation. I have a 2000 2.8L ATQ that was leaking coolant. It's all torn apart and I've ordered parts that have come in, however I think I may have incorrectly ordered o-rings. Specifically from the REAR COOLANT PIPE. Checking this site oemepc...

Where can I find info on these o-rings, or purchase them? I need to know diameter, size, material, etc. I am in a hurry to find some since they may help me get home. A duct blew apart on the way to work. I stopped and found the cause of the noise and loss of power, and I can put the two parts...

Just installed a used engine in my garage and got it running. It sounds good and runs smooth...but it has a bad coolant leak. I traced it to the hard metal line that runs underneath the intake manifold. I need the part # for the o-ring that seals the smaller hard line for flow from the heater...

The hose line connectors that go to the washer fluid pump have a small O-ring inside, due to age and multiple pump replacements mine are leaking... want to source the parts before I replace the leaking little buggers...anyone know what OD x ID x thickness these things are? Much appreciated if...

replacing a coolant flange for a friends b6 a4, 1.8t amb. leaking coolant on the back of the cylinder head, usual common issue. but when i removed it the o-rings are swollen to about double the size as when they were installed and very spongy. i know the usual cause of rubber swelling like this...

sorry - moved to b5 section

Hi, I will do a compressor change + some service to my A/C system soon. I guess that I need to replace the O-rings for the connections I opens up. The O-rings used are standard sizes, but does anyone know which O-ring material used? I plan to buy these from a hardware store rather than genuine...

The radiator hoses and heater hoses on my 1.8t are fine but while I have the car apart I would like to replace the o-rings that go inside the plastic connectors at the ends of the hoses. VW (unbelivably) does not sell these o-rings separately. Any ideas on a source??? Thanks J.Calhoun

Trying to reduce a slight rich condition, I replaced the injector o-rings on the bottom of the injectors. The ones that seat into the intake manifold inserts.Showed signs of slight leakage on the manifold from 3/4 injectors. Set of 4 from Advance Auto Parts, Fel-Pro part #ES70599, $2.86, in...

I had to replace my fuel injector O-ring on one of the injectors it was completely missing and was throwing a check engine light code it had a p1138 and it was running lean. When i restarted the car it stumbled and for some time after it was running like crap as I drove it more it had got...

I have a '99 1.8T and I have some fuel leaking around my injectors where they meet the manifold. I have the o-rings I just want to know if anyone has done this before I start taking things apart. Should this be covered under the powertrain warranty by any chance? I have had some very minor...

Ok, so I picked up the ECS tuning ultimate timing belt change kit. Getting ready to make sure I've got everything I need for the job. As I'm reading Chilton manual, it refers to a few gaskets and o-rings that should be changed when removing parts for the timing belt job. Questions: 1) How...