Search Results for ‘negative’

Hi guys! im new to this but i have been reading forums for years. i tried serching but i couldn't fine anything. I need help finding the POSITIVE AND NEGATIVE signal for the central locking system? Can anyone help me out? The car is a 2002 Passat European. There is nothing wrong with the system...

can anyone tell me what the third lead is for on my Passat have positive negative and a smaller lead???:banghead::banghead:

like the title said, i find crazy negative camber wheels ugly and so disgusting. dont get me wrong, im good with slightly and functional negative camber, as a matter of fact, stock setting of some car is a little bit negative, they are totally fine. but some guys mod their wheels into super...

Hi, I have a 2.8 V6 4motion. Can anyone tell where I should clamp the negative clamp on my battery booster, space in the engine bay is limited. I've been clamping it to the negative battery post but I recently read this is dangerous as the battery has gasses that can explode :ambulance: if it...

Its a 2000 1.8t Recently I had to put in regular for a short while due to fuel prices ( thank god it went down now ) and I noticed it was sort of sluggish off the line. The throttle response was laggy or slow as in I would touch the gas and the car would feel strained. Which really bothered me...

Hey guys, I wonder is it possible to turn on (but not Engine) car while minus or negative terminal is disconnected? :confused: Just to turn my steering wheel 90-180 degrees

Have had success on here in the past, and was hoping someone could give me some more specific advice than what I've found so far though a ton of googling. Currently I am experiencing a loss of boost in acceleration, not hearing that all familiar pssss when I hit the gas. The code i'm getting...

Battery Drain - Fuse 14 CCM 600 mA draw for hours I recently got a new battery and it has died a couple of times. LCD clock doesn't even show. Battery down to 5 volts. I got it charged up to 12+v again and the car runs fine. Alternator tested OK. I did notice that when I connect the negative...

Yes, the midwest storm is as crazy as the news tells you... My car wouldn't start so I had a tow truck come by and jump it. He used a jump box and had to have the engine grind for a good 45 seconds to a minute before it finally came to life. While it was grinding I saw the following on my...

As soon as I thought everything was perfect. ;) VAG-COM Version: Release 311.2-N Control Module Part Number: 4B0 906 018 Q Component and/or Version: 1.8L R4/5VT G 0006 Software Coding: 07551 Work Shop Code: WSC 30011 4 Faults Found: 17964 - Charge Pressure...

I had my 2004 VW Passat up for sale, 43,000 miles, pretty gently driven 1.8T wagon. This vehicle is also covered by a VW used car warranty that expires next summer--as I drive very little, there is no way it will expire by mileage, only time. A prospective buyer took the car into our local VW...

Any idea what this is about? i am stumped and searching only brought up minimal data. fuel trims are -2.3% and -25% :icon_eek:, i need to check into that, also my post cat O2 is dead but that shouldn't cause that issue should it? i cleared the P1556 and it came back so something is not...

I have a 2000 passat 1.8t apu. Car is chipped to 1.1bar health turbo I think all vacum hoses and boost hoses are ok but am only making around 13 -15 psi. N75 valve ok all PVC system replaced but still get the negative boost deviation code!. Tried running without wastgate control but no luck...

I am trying to install a motion sensor to my factory alarm. I tried splicing into the brown and black wire which is the trunk trigger and then I tried the blue and gray wire which is the door trigger. Am I missing something here? I would think I could just splice the trigger into one of the...

Got this error: 17961 - Charge Pressure Control: Negative Deviation P1556 35-10 Intermittent I have an MBC on my AEB and have been slowly bringing up the boost and watching my fuel trims (32) and my knock sensors (20). I am surprised by this error because I understand my engine can't measure...