Search Results for ‘hoses’

Hi guys, It's me again. I think I've got a boost leak on one of my (stock) intercooler hoses, so I was researching and found these Chinese silicone ones: GPLUS FIT FOR 94 - 05 AUDI A4 VW PASSAT B5 1.8T SILICONE INTER COOLER TURBO HOSE | eBay They're very cheap, and I guess you get what you...

I wondering why on a lot of the vacuum hoses like to the combi from that cluster on top of the manifold in the rear top of engine. Question they go from a large hose to a small plastic then back up again at the other end.Can I just replace with one size rubber. Whats the point. 2003 Passat V6 2.8l

Question? What kind of life are you all getting from your coolant/heater hoses? My 2005 TDI BHW engine code has over 200,000 miles and all the hoses (except elbow hose for the rear flange, it's 5 years old and 70,000 miles), are original. They all appear to physically look good. Given the...

Need help. My sons 03 passat needs new breather hose that comes off the back of the valve cover. Would like to find a kit to replace all the silicone molded hoses. Anyoneknow of a kit that would do this and not break wallet.

I mistakenly ordered the PCV breather hose and suction pump for the earlier B5 platform (have a 2002 ATQ). It was listed incorrectly as for my vehicle and once I did the reading and looking around in the engine bay I realized my mistake. In taking a look at the hose that was on there before...

In my on again, off again project I took the heads off 2003 ATQ V6 including intake manifold and all vacuum hoses and Breather hoses. Then I managed to lose all the pictures I took of it. I can't find a diagram of the breather system in the Bentley manual. Can someone please refer me to the...

Is it worth it to replace B5 PCV breather with B5.5 valve/piping? What parts do I need except obviously the valve itself and the pipes?

Hi All: I've to get 2 heater hoses that are behind the firewall and going through the engine replaced. One is them is leaking minutely and the other one is about to die. This is what the dealership told me after I told them my coolant tank might be leaking. Cost of replacement about...

Tips on doing my breather hoses by removing the Intake Manifold??? I tried to do it without removing the IM but im cursed with fat hands lol, i will be removing the intake manifold and im sure doing this i should replace the Intake Manifold Gasket and Fuel Injector O-Rings right? Am i missing...

So I have a passat I purchased used from some kid and some of the work or fixes they or he has done looks hacked up at best. Anyway I guess it works but it needs to be corrected. The engine cover that makes the motor look fancy is gone as well as the cover for the back part under the hood that...

Hi all, I'm trying to drain out my gas tank due to it having possibly bad gas. I saw how much rust was around the area. It's gotten to the point where the clamps cracked off and the hoses are completely tight on it and I can't budge the large cap off. I think water / snow snuck its way up...

Working on a 2003 V6 GLX 4motion. I am putting it into service position now. Ive got everything unhooked as usual, disconnected both of the large radiator coolant lines, just as I was ready to pull off the radiator, I noticed another set of hoses going into the radiator that I've never seen on...

Hello everyone, My 2001.5 Passat (1.8T AWM) has idle rough issue in the past couple of years. I cleaned MAF, Throttle body valve, and replaced spark plugs and coils. None of them helped much. In the end, I replaced PCV valve. When I removed old PCV, it had black gunk similar to what we see in...

Hello forum, some of you may have read my last threat about my loud turbo.. Heres my scenario and question: (2001 VW passat 1.8t 220k miles) About 3 weeks ago, i was doing so compartment cleaning and check up, checking oil filters ext. on my truck and VW. When i was putting the vw back...

Hi , I was investigating cracked vacuum hoses and decided to check out my PCV system and tops of the spark plugs. I have a 01 B5 V6 at 60k miles. I have do not have any noticeable oil leaks from the perimeter VCGs or smell at all. Consumption is marginal. When I took off the cables to each of...

So I am almost done with the head replacement on my 2005 4 motion wagon 1.8t. got all the vacuum hoses (German over engineering is a bit annoying) hooked up, but I'm putting the throttle body back on and the plate that attaches to the under side of the intake manifold that has the electrical...

While I was cleaning the leaves out of the drains I realized that the heater tubes aren't even connected. The heater has never worked and I never really looked into it but this was pretty obvious when I noticed it. Is there some reason somebody would do this? I bought the car like this so I...

I put a brand new diverter valve on about 5k miles ago and notice i have been losing oil. About a quart every 1000-1500 or so miles. So today I was looking under car and notices their is alot of oil all over the hoses and the diverter valve area. Does anyone know where I should start looking for...

I'm Mark Bondurant, near Cincinnati, OH, and own a 2002 Passat 1.8T, which I purchased to replace a 2003 Jetta TDI that needs a new cam and lifters. So far I love this car, but am getting into some maintinance issues. I had the car in for an oil change (usually I do my own, but time did not...

I am having difficulty keeping the S shaped turbo hose ( from turbo outlet to transverse pipe under radiator) connected. I've cleaned (as well as I can) both ends of that hose and snapped it in place but it continues to work loose. Is this a somewhat common problem where the clips wear to the...