Volkswagen Passat Forum banner
hair
1-10 of 27 Results
  1. B5 Garage
    Both marks are like this except on exhaust cam its on opposite side of mark. Do I need a new chain or will tensioner take up slack ??
  2. New Member Introductions
    Looking for some help. I am trying to repair my sons car, as inexpensively as possible. I do not have vag-com, but willing to get if someone can tell me exactly what i need! Here is what the car does (seemingly only when ambient air temp is above 73 (but does not happen every time it is above...
  3. Volkswagen Passat B5 Discussion
    Ok, I replaced the engine in my daughters 2005 Passat V6....put it all back together...started the car, put it in reverse....nothing.....nothing no matter what gear. Ck'ed the trans cooler lines with the engine running and no flow. So, I pulled the motor and trans back out and cracked them apart...
  4. New Member Introductions
    Hello-my passat EPC light is on, and the car keeps cutting off. When I try to restart it, it sounds as if it's going to turn over then wont. So I wait for a few seconds then try it again, then it starts. The check engine light came on, and I know now, that I also need a 02 sensor. Just about...
  5. New Member Introductions
    Hey Guys, I am pretty new at the site but i will try to get the hang of . Joined to share and learn about passat as mine is driving me insane 2001.5 vw Passat. 2.8L v6- Manual transmission (B5)
  6. B5 Garage
    Codes read multipal misfire, misfire cylinders 1,2,3,and cam position sensor. replaced Cam postion sensor cleared codes and everything seemed to be fine. less than 10 miles later CEL back on. Codes read same as above now with a cam position sensor circut code.... Checked everything over and...
  7. B5 Garage
    The CEL came on and they were P0118 (Engine Coolant Temp), P1411 & P1423. I changed the engine coolant sensor which solved the car not starting with a hot engine, but all the codes are still there...two weeks after I did the work. The car starts fine now when hot...but the damn codes are still...
  8. Mobile Electronics
    ......and decided to deaden my doors. Enjoy. The door with the internals removed and degreased. I found a crossthreaded bolt for the door latch mechanism from the fatory too. I wonder if I can re-tap it??? Dynamat Extreme applied Dynamat TAC Mat applied Dynamat Dynaxorb damping pads...
  9. The Showroom
    ...and decided to deaden my doors. Enjoy. The door with the internals removed and degreased. I found a crossthreaded bolt for the door latch mechanism from the fatory too. I wonder if I can re-tap it??? Dynamat Extreme applied Dynamat TAC Mat applied Dynamat Dynaxorb damping pads...
  10. Volkswagen Passat B5 Discussion
    OK, so I had these bent rims from the previous owner that curbed the crap out of them... so i swapped them to some steelies because i was getting nasty shakes from them... or so i thought. Got the new rims, and still getting the shakes, so I thought next the problem was warped rotors... got them...
1-10 of 27 Results
Top