What would cause this tube to keep breaking? I have replaced three times. Does anyone make a metal version of this (06A103213F)?

I found this part online but doesn't seem to match exactly to what I have in my 02 Passat 1.8t. It says it fits 1997-05 Passat. Vacuum Check Valve Breather Hose Assembly There is a 2nd one on Amazon that appears to be identical part but more money. Anyone know if this will work or not? The...

I wondered how hard is it to change crankcase breather lower hose. how hard is it to get to the lower end to these hex bolts. Is it somewhere behind oil filter? engine is1.9 tdi 81kw Also can clogged breather cause poor performance specially on higher revs.? i mean this thing:

The old 2004 is now past 164,000km and now the O-ring seal on the breather tube above the oil filter housing is leaking. Not really a bad leak, but you know.:nervous: I know the tube will fracture when I try to remove it, no biggie, but I read that getting the new one in with the new O-ring is...

Ok so I replaced the Crankcase Breather Vacuum Vent Hose Pipe Tube but it's missing a tube that goes down behind the valve cover Is this the part I need to complete this?: Engine Crankcase Breather Hose Tube #078103223B I want to finish this project & how hard is it to replace the tube that...

Title pretty much sums it up. My breather hose was cracked when I first saw it Sunday. Then this morning I was having really rough starts, so I popped the hood to look at the culprit. The damn thing was hangin out underneath my manifold. Couple questions. What do I risk by driving this the...

ATQ breather hose replacement for illustration ETKA 103-80 VW part # 078103223E using a $6 Autozone part with 1 inch of rubber removed from on end. The AZ part # is 70647 code A and fits between the puck valve and the breather hose that sends oil back to the crankcase. I also removed 1/4 inch...

Tips on doing my breather hoses by removing the Intake Manifold??? I tried to do it without removing the IM but im cursed with fat hands lol, i will be removing the intake manifold and im sure doing this i should replace the Intake Manifold Gasket and Fuel Injector O-Rings right? Am i missing...

I don't know if I can get $10.00, but I'll ask for that. OEM part. $3.00 shipping. 4

...Attempting to fix my pcv system today and lo and behold this part - VW part number 078103235k - literally crumbled at both ends. I suspect it was leaking fumes anyhow, but when i went to remove the PCV valve, it literally crumbled apart. It's the rear breather hose, you know, the one I...

How do i know which one fits my car? These look like what i have but I'd rather be sure first, 2003 V6 Passat GLX 4motion. I know it does has the hockey puck but I was told there are a lot of variants how do i get the right one...

Started working on my EVAP/SAIP/Vacuum issues and found the crankcase breather pipe disintegrated. This left the copper ring stuck solid in the casing below. Brute strength caused me to break the crankcase breather "thingy" that the pipe goes into, the cut out part that the clip slides into to...

Can someone tell me the difference between part # 06B103221F and 06B103221P? It's the 3-way breather hose near the back of the engine. Mine was split at the bottom so I grabbed another from the dealer with the same part number (06B103221F), but it appears that it's too short? If the bottom part...

So I'm doing the lovely PCV replacement, of course the breather pipe thing broke off and had to wiggle that stupid metal piece out (found a cool tool for that, more on that later). Its a 2005 GLS 4motion with 1.8T So I have the breather pipe, and that T - hose put together, try to dry fit it...

I know that the PVC replacement has been touched on a lot here. Thats not my issue! My issue that has risen is after I replaced the valve cover gaskets and put on a new PVC breather hose because my 2003 V6 Passat (4 Motion) was leaking oil. I will be honest I did not do the job myself due to...

I have done a good amount of research on this to no avail. More info is always better than less in my experience so let me start from the beginning... This is my 3rd b5, my first 2.8 though. I bought it just before winter with a little over 100k miles. I planned on doing the timing belt and a...

I have a 2003 vw passat 1.8t AWM engine. Earlier I installed a new coolant flange and now I can see that the Breather Tube (06B103213G) seems really clogged and may need cleaning. There is a welded metal piece attached to the tube that is bolted together with the flange at the rear of the...

My car has been throwing the following codes for the past month and recently, the engine is running a little louder: 2003 Passat 1.8t AWM 1. Multiple misfires on all cylinders 2. Lean on all banks 3. Any and all similar codes Today, I found the breather tube to be broken off and laying on the...

I cracked the crankcase breather tube on my 2005 B5.5 ATQ AWD Wagon while replacing my leaking valve cover gaskets. Right now silicone tape seems to be keeping things together, but I need to replace the part. My VIN is WVWYU63B15E****** I'm trying to find a replacement and ECS shows this part...