Volkswagen Passat Forum banner

bank

  1. Bank 1 Random Misfire, 123

    Volkswagen Passat B5 Discussion
    Hey Guys, Hit a wall here. I have a 02 2.8, ATQ, got everything back together, all timed, etc. when I started it, ran great for a few minutes, now I’m at random misfire and misfires on 1, 2, and 3. Misses like hell at idle and pops a little here and there, no power. Around 3k seems the mis goes...
  2. 16395 - Bank 1: Camshaft A (Intake) P0011 - 002 - Retard Setpoint not Re

    Volkswagen Passat B5 Discussion
    Hi Everyone, 2003, 1.8t, AWM, 124.000 miles. I got my first CEL last week having driven 11.000 miles since I bought the car. I did a complete TB replacement as soon as I bought the car. I replaced the cam chain adjuster, which I bought from FCP. 16395 - Bank 1: Camshaft A (Intake)...
  3. Bank 1 System Too Lean P0171

    Volkswagen Passat B5 Discussion
    I am receiving the P0171 CEL code with Bank 1 System too Lean. The car runs completely fine, no misfires and no rough idle. DEQ gave me a print out of their diagnostics which is as followed: misfire- ready fuel system- ready component- ready catalyst- ready catalyst heater- unsupported...
  4. V6 Passat Catalytic Converter Codes 16805 (Bank 1) and 16815 (Bank 2)

    Volkswagen Passat B5 Discussion
    I'm getting these two codes that crop up about every 200 to 300 miles or so on my '03 Passat V6. They always come up together. After doing a lot of reading/researching, most people simply replace their cats when these codes come up. However, I REALLY want to avoid that since I am in...
  5. 2.8L V6 '99 Passat Cylinders 1,2,3 (Bank 1) Misfires

    Volkswagen Passat B5 Discussion
    Hello everyone, Let me start with promising that I've searched the entire forum for related information and could not find a solution. 2.8 V6 '99 Passat, AHA engine with 170k miles. The problem started about a month ago when my CEL started flashing. After I read the codes they were P0300...
  6. Fix for P0421 - Warm Up Catalyst Efficiency Below Threshold Bank 1

    Volkswagen Passat B5 Discussion
    My 2002 V6 ATQ (191K 29MPG Highway 23 City) was due for state inspection so I needed to come up with a fix for my P0421 P0431 CEL codes. I planned to replace both rear O2 sensors, but first wanted to be sure this wasn't due to poor combustion performance or an exhaust leak. So I put 1 bottle...
  7. p0010 camshaft position actuator A bank 1, circuit malfunction

    Volkswagen Passat B5 Discussion
    Hi guys, I did some research on this issue and still need some help. I get the p0010 camshaft position actuator a bank 1, circuit malfunction. So, I figured it may be an 'electrical issue' of some sort. I changed the camshaft position sensor and still doesn't work. I read to test the solenoid...
  8. Car catches then cuts out? Error code is P0016? which are camshaft sensor 1 bank A?

    Volkswagen Passat B6 Discussion
    I have a VW Passat 2Lite TDi Volkswagen AG Type 3c Turning on my car it catches then immediately cuts out. At first I thought it was the fuel cut off switch or the injectors, cracked the nut on the injectors fuel was coming through, re-tightened and just tapped the cut off switch and it...
  9. p0421 bank 1, p0135 B1 S1, p0155 B2S2, p0431 Bank2

    Volkswagen Passat B5 Discussion
    2002 GLX Sedan, car is running fine but the check engine light just came on with these codes: p0421 bank 1, p0135 B1 S1, p0155 B2S2, p0431 Bank2 If it was one side or the other I would replace the O2 sensor or add an anti-fouler, but suddenly all four of these codes at the same time and the car...
  10. 2010 CC 2.0T - code 008583 - Bank 1; System too Lean at Idle - P2187 - Intermittent

    Volkswagen Passat CC Discussion
    Not sure what my engine code is (EA880 or so? Or another 3 letter code)? What might cause the 'system lean at idle' code? How to troubleshoot?
  11. How to verify Timing alignment for 01 Passat GLX V6 Bank 2

    New Member Introductions
    I am thinking to put crankshft to TDC position, lock the cranshaft and camshaft, then count bank-2 chain (16)? Thanks for any suggestions!
  12. Intake Camshaft Position Timing - Over-Advanced (Bank 2)

    B5 Garage
    Just plugged in my OBD2 meter and got this reading: Intake Camshaft Position Timing - Over-Advanced (Bank 2). My ABS light came on too and the check engine light. Car didn't want to start so I plugged er in. Any ideas guys? Any idea on cost? Probably have to take into the dealer...ARGH :banghead:
  13. rough idle and Bank 1 issues, please help

    Volkswagen Passat B5 Discussion
    Still trying to get my 2000 2.8 wagon running good. It's been down since early December. It starts and drives but as soon as it's warm I have a very rough idle. Plugs foul in cylinders 4,5, and 6. Timing is right on, compression is high in all cylinders. Also, have checked coolant temp...
  14. O2 Oxygen Sensor Passengers Side Bank 1 Upstream Pre Cat Replacement

    B5 Garage
    Attached are some pictures of how to access this sensor for replacement. The access is very tight, but doable. Before I took the pics, I already removed the airbox. The additional items that have to be moved out of the way are shown in these pics. This also allows access to the top nut...
  15. Correct O2 Sensor Bank 2 Sensor 2

    Volkswagen Passat B5 Discussion
    I had the CEL and was getting codes P1140 and P1110 which I noted as being the post cat oxygen sensor for bank 2 sensor 2. I ordered the sensor from Amazon which was the Bosch 13552. Amazon didn't think it fit my car, but AllDataDIY and Rock Auto both list it as the correct sensor. I...
  16. 008213 - Intake Manifold Flap Position Sensor (Bank 1) My Solution.

    B6 Garage
    Hi. This is my first post here. I'm not english, and my english is not very good, but I will try to explain as good as i can. Hope you will understand it. I live in Norway at the moment, immigrant from Lithuania... Yep. Did some mechanic job back in my country, now I do logistics in fish packing...
  17. P0155 02 heater Circuit (Bank 2, Sensor 1)

    Volkswagen Passat B5 Discussion
    I have a 2004 Passat 2.8 30V engine. It is throwing code P0155 - 02 heater Circuit (Bank 2, Sensor 1). My question is which side is Bank 2 (driver/passenger, right/left (viewed from which direction))? Also, would Sensor 1 be the first one from the engine? Thanks in advance!
  18. leaking camshaft adjuster on right bank

    Volkswagen Passat B5 Discussion
    Is this a problem noted for the B5.5 ATQ engine ???. Just put on new head gaskets and plugs thinking that would solve my oil leak problem on right bank...But, that did not do the trick. There is no cam seals on this end of the head, only the cam adjuster, did tighten 3 screw 1/4 turn each but...
  19. CEL PO171 & PO141. O2 heater circuit bank 1 sensor 2

    B5 Garage
    In the past month I replaced the MAF sensor due to a CEL for it and hard shifting in morning from reverse to drive, that took care of that, I also cleaned my throttle body...just because I have 170,000. I have replaced the vacuum lines about 35,000 miles ago. So after a 550 mile road trip, I...
  20. misfire

    Volkswagen Passat B5 Discussion
    hi guys. having problems with my vw. 2.8 v6. was running kind of rough and i scanned it with a vag. got back: p0102 and p0300, p0301, 302 and 303. so the whole left bank is misfiring. anybody know what would be the reason for that?
Top