Volkswagen Passat Forum banner

access

  1. Access Granted????

    New Member Introductions
    I hope this works
  2. Replacement jacking-point access panels ?

    Volkswagen Passat B5 Discussion
    In scraping the slush off the rocker panels, I broke off that little access panel that you open to jack up the vehicle. The plastic pivot-point clips broke beyond saving. Does anyone know where I could find such an odd part as this ?
  3. Coparts Access anyone?

    Volkswagen Passat B5 Discussion
    Hi, I was wondering if anyone has member access to coparts. Reason being I needed to get a parts car to fix my own car up with (Lexus), and just having to get a broker would add a lot of expense to the amount I have. Thanks for your time. Wmj
  4. 12V access

    Volkswagen Passat B6 Discussion
    Good afternoon all I am installing a USB charge port in place of my cigarette lighter. Began the install last night, My original plan is to go through the firewall and direct to the battery. But I was wondering if there is a point inside the car that I can tap into a solid "always ON" 12v...
  5. Access to Passenger's side Cam Tensioner cap bolt?

    B5 Garage
    Hey guys, Just went through the nightmare of changing the half moon seal and gasket on the ATQ passenger's side, hopefully it doesn't leak because I had little to no room to get things done even though tool 3366 had the chain slackened. Now I'm trying to do the cam tensioner cap on this side...
  6. 3 posts, still no access to some forum topics

    New Member Introductions
    No access to Dyno forum.
  7. Posting my second one to get access to really post

    New Member Introductions
    This is my second post and I have repied to two posts also. I think this should allow me access.
  8. Access door before air filter?

    Volkswagen Passat B7 Discussion
    So have had a P0106 code for awhile and finally got around to replacing the barometric pressure sensor today. Not so hard to do. Removed the air filter assembly, then the air intake hose, and then the throttle body. A few electrical disconnects along the way and I had access to the pressure...
  9. Not a new member - can't get a temp password to access my old account

    New Member Introductions
    I had to re-register using a different name because I have yet to receive an email with a temporary password so I can log in and change my old one. I've been locked out of my old account and have sent numerous messages to the site administrator with no replies. Now I can't even post a message...
  10. Swapping an 1.8T, what to replace whilst I've got easy access?

    B5 Garage
    Hi everyone, I am in the process of converting the engine and transmission in an old east-German Van (Barkas) from a crappy 2-stroke to the 1.8T from a VW Passat. I've got the donor car sitting ready to be slaughtered, it's from 1998 and travelled 250k kilometers. Since I'll have the block...
  11. Help needed if you have access to a 451 MFL MFSW relay and VCDS

    B5 Garage
    Hello there, This might be something like a follow-up from this thread but in a more specific matter. According to VCDS, the MFL MFSW relays can be recoded the following ways: As I'm stuck right now, my relay refuses all the codings except the 00008 which makes the phone button on the left...
  12. Cam Cap 7 T30 bits, special tool to access? (pic)

    Volkswagen Passat B5 Discussion
    Hi all - I am working on the pax side bank. I managed to remove all cam caps and the camshafts, but the T30 fastener on cap 7 is going to be impossible to torque back down properly due to the proximity to the body metal. I just about ruined the bolt extracting. The gap is too small for a T30 bit...
  13. How to access lumbar support mechanicals inside the front driver's seat?

    Volkswagen Passat B6 Discussion
    Hello B6ers! My lumbar support mechanism is not working. I can hear the motor whine, but it does not seem to be moving anything. Perhaps the cable (or whatever) that connects the motor to the lumbar mechanism is broken. Short of cutting off the leatherette fabric, does anyone have ideas on how I...
  14. Forum access.

    New Member Introductions
    Is it after 2 posts in the Noob section you can access other areas?
  15. Remove tranny mount bolts for easier access

    B5 Garage
    I need to replace the coolant flange on the rear of the head. This is on an 01 1.8t AWM car. Has anyone removed the 2 transmission mount bolts and lifted the rear of the trans to allow easier access to this flange? I do have the car in "Service mode" so I don't have to worry about hitting...
  16. Remove tranny mount bolts for easier access

    New Member Introductions
    I need to change the dreaded coolant flange on an 01 Passat AWM. Has anyone removed the transmission mount bolts & jacked the rear of the tranny up to give more access to the rear of the head?
  17. Microsoft Access - gurus

    Off-Topic Forum
    Anybody out there who has knowledge of building an Access database? I'm a CNC programmer and I am wanting to grab information and put it into a what we the industry call a "tool list". For example: T1 H1 1.5 SANDVIK FACE MILL ( ROUGH ) - ( 3 PITCH ) R390-17...
  18. Access to any thread...logged on or not

    Community Help
    Can't access content of any thread, regardless of whether or not I'm logged on. :crazy: Would've bumped the access thread from late Sept. but it can't be accessed. (no pun intended) Edit 90 min later - Now I can see, yet still can't do a search on the B5 Information Base. Looks like search...
  19. Posting a new thread to get my 'access' points

    New Member Introductions
    Posting a new thread to get my 'acess' points
  20. Noob Tube - Trying to get access

    New Member Introductions
    Post 3. I have had a 2001 2.8L V6 5 speed GLX for about 5 years. Love my car, however Ive had some issues due to my own human error. After months of living with the issues I have arrived here to gain some insight and resolve my problems. I am going to navigate the site to try and find some...
Top