I recently discovered an exhaust leak that turned out to be a broken v-band clamp on the stock turbo from my 2010 2.0T TSI engine. I've attached a picture of the broken one, and a new one that I found online (after much searching...). VW do not list this as an individual part...
My 2008 Passat 2.0T, 6 speed manual, black, black leather interior.
Hit in Left front by a drunk driver while parked on the street.
This would be a great car for someone wanting to swap from automatic to manual!
Can hear it run, not driveable. Not parting out.
Located in Denver CO...
im new to vw. stepdaughter crashed her 08 passat 2.0t. smashed the front end. i got a radiator, intercooler trans cooler etc from a salvage yard to try to piece this car back together. the first major issue i ran into is the radiator seems to be different than what came out. both radiator hoses...
I have 2 codes that might be related (from other posters/forums):
008328 - Bank 1 Camshaft A (Intake) Position Actuator
P2088 - 002 - Short to Ground
001681 - Fan 1 Control Circuit
P0691 - 002 - Short to GND
I need the wiring diagrams (2006 Passat 2.0T auto FWD, BPY engine) for both...
'10 B6 ~75k miles. TSI engine running great. Need a new water pump. Thinking that replacing the original (faulty) timing chain tensioners is an absolute no brainer. Supposedly, VW redesigned the tensioners. My questions:
1) are the tensioners, in fact, redesigned?
2) does anyone know the part...
Still have not found a good fuse diagram for the 2006 Passat 2.0T ; looking for left, right panel, relay panels, engine bay fuses/relays.
Current trying to find out if there is a fuse for the airbag module, since 2 modules I tried both show 'no communication'.
Photo of my driver side (left)...
I have a 2008 2.0T FSI, 09g Trans 6 spped TIP
cant select 3rd gear in TIP Mode it over revs in 1st when slecting TIP then back to drive it goes into neutral, have fittred a new valve body no difference
The Oil was very Grey in colour
Any Clues please
I had the intake of my BPY engine (carbon build up cleaning, timing belt, cam chain/tensioner, vac pump seals, etc).
3 injectors came out (cyl 1-3), on stayed in head.
After installing intake, gas is gushing out (and engine not starting) from under the intake (not exactly located).
Doin' my time in the NoobTube.
Just picked up a 2007 B6 2.0T Wagon
Lowered on KSport Coilovers, seems to have some interior / dash mods
I'm new to VWs, but not to modding; first car to come with someone else's mods, though.
Ordered passenger CV axle (aftermarket).
Length seems to be the same, but the OEM appears to be bigger diameter and hollow, vs. the new is small, solid.
Should i use it?
Need to replace both CV axles of my 2006 Passat 2.0T FWD.
Pulled both axles, but the 'cup' stays on the tranny.
Is it held by a spring clip and needs to be 'yanked' out?
The flex pipe (back of engine) is broken.
While cheap downpipes are available for other 2.0T (recently bought one for my 2006 A3 FWD 2.0T), i can't find a reasonable (i.e. cheap) downpipe listed for the 2006 Passat 2.0T. Or I am not looking for the right model. Is the there a model that cross...
How can I remove the chrome trim off the front and rear bumper?
I need to prepare the bumpers for a fresh paint; clear coat peeling (seems to be a common issue on the VW and Audi I own/owned of that generation).
Also: the "build" sticker (normally in the trunk; spare tire well?) is missing...
I have had this car since new. Still love the way it drives, but have suffered from the oil consumption problem since day 1. Usually add about half quart of Castrol synthetic oil every 1000 miles. I have never replaced anything related to this issue. Since I have had this problem since day 1...
I the cat, flex pipe and whatever comes after the flex pipe all one piece?
Are muffler shops able to cut flex out and weld in new?
If not, I would replace the cat, flex pipe with a catless downpipe (and tune out rear o2...