Search Results for ‘002’

Hi Everyone, 2003, 1.8t, AWM, 124.000 miles. I got my first CEL last week having driven 11.000 miles since I bought the car. I did a complete TB replacement as soon as I bought the car. I replaced the cam chain adjuster, which I bought from FCP. 16395 - Bank 1: Camshaft A (Intake)...

I am curious which is the 2nd fan? Drive or passenger side? or should I say big or small fan. Almost blew the engine last night stuck in traffic, turned on the heater full blast to cool it as much as I could and finally it went back to normal.

Catalyst System failure, Bank 1, Efficiency Below Threshold - po420 - 002 - Lower Limit Exceeded - MIL ON. First signs point to Converter Failure. After I cleared the code, I noticed alot of failures under the readiness box in VAG. Can this be anything else? Any advice on replacing the CAT...

car is 01.5 awm. what do you guys make of the following logs? as bvariant mentioned, air mass seems low.. i'm not letting off at all, it looks like the engine load peaks at ~3200 rpm and goes down from there on. is this normal? I did get a CEL during the first run (i think that's the same as...

didn't know if this should go here or dyno section. so it's here can somebody look over my 002 logs to tell me if my boost is too much 3rd gear run. 99' AEB 1.8t W/ MBC @ 10psi. caom and boost guage are the only other ups. couldn't go all the way to redline because i ran out of road and i...

Here's my latest: http://129.125.253.199/VW/Dyno_Block_120_115_002_20050215_4.htm Data is old but still reflecting my current setup, I've recently added AFR and Duty Cycle to the chart. Any suggestions for enhancements?

Here are two logs of blocks 002 and 031 respectively. Passat 1.8T Tiptronic modded. The logs are short due to being done in 2nd gear. Please post your comments. I haven't dynoed the car yet so I am trying to guage if I have a good afr up top. '002 Idle Speed Engine Load Inj. On Time Air Mass...

I’ve been trying to create a spreadsheet that can calculate the air fuel ratio from the data contained in block 002 of the ECU in my car. The important data is engine speed (rpm), injector period (ms) and air mass in (g/s). From a bit of research, I found that the density of Shell Optimax is...

I've recently made an adapter cable for VAG-COM and started logging some data with it. I've read posts about the maximum injector period being 16.32s for the AEB motor. So I was very surprised when I saw a peak of 21.16 for the injector period in block 002. Am I using the wrong block, or is...

On the reservoir is written "only mineral oil" and "G 002 000". Just bought from VW dealer original VW/Audi "Oil for hydraulic systems and power assisted steering", same number on container as on the reservoir: G 002 000 but synthetic, not mineral. Is it ok to complete using this synthetic...