p1392 and p1626
NEWS
 

+ Reply to Thread
Results 1 to 5 of 5

Thread: p1392 and p1626

  1. #1
    Neutral
    Join Date
    Dec 2009
    Location
    Tulsa, OK
    Posts
    103

    p1392 and p1626

    99 passat GLS V6 2.8l 5 speed manual. These codes come on as a pair at the same time. Sometimes a p0300 and other 3 misfire codes (forgot which ones but it don't really matter). Sometimes it takes a lil drive for these codes to come on but usually they pop up right at engine start. What is the problem? Why do I have transmission control unit code if I have a manual transmission? Which side is bank 1 and which side is bank 2 if I have to replace the camshaft position sensor? And last question: What symptoms would I have if the engine had a misplaced timing belt by a tooth, or/and a misplaced cam chain by a tooth? I recently did the valve job on this engine. First engine I actually rebuilt myself, don't have mu ch experience, so I think i might have misplaced something there, but the car runs really good. Lotsa power and good gas mileage. Any help?

  2. Remove Advertisements
    VW Passat Forum
    Advertisements
     

  3. #2
    Neutral
    Join Date
    Dec 2009
    Location
    Tulsa, OK
    Posts
    103
    No clues

  4. #3
    1st Gear
    Join Date
    Jun 2008
    Location
    Neenah, WI
    Age
    30
    Posts
    227
    17800/P1392/005010 - Camshaft Position Sensor Bank 2 (G163): Open Short to Plus
    Possible Symptoms

    * Power Loss at Full Throttle
    * High Fuel Consumption
    * Bad Emission Values

    Possible Causes

    * Wiring between Engine Control Module and Camshaft Position Sensor Bank 2 (G163) faulty
    * Power Supply/Ground Wiring from/to Camshaft Position Sensor Bank 2 (G163) faulty
    * Camshaft Position Sensor Bank 2 (G163) faulty
    * Engine Control Module faulty

    Possible Solutions

    * Check Wiring between Engine Control Module and Camshaft Position Sensor Bank 2 (G163)
    * Power Supply/Ground Wiring from/to Camshaft Position Sensor Bank 2 (G163) faulty
    * Check Camshaft Position Sensor Bank 2 (G163)
    * Check Engine Control Module

    P1626 Data Bus Powertrain missing message from Transm.Contr.
    ... sorry not sure what this one means... could it be that a problem with your ECU is causing this one too?

  5. #4
    1st Gear
    Join Date
    Feb 2010
    Location
    Chicago
    Posts
    193
    you shouldnt have a TCM (Tranmission Control Module) if your car is a 5 speed. Recode the ECM so that it won't look for it.

  6. #5
    Neutral
    Join Date
    Dec 2009
    Location
    Tulsa, OK
    Posts
    103
    It was a misplaced cam chain by a tooth.

  7. Remove Advertisements
    VW Passat Forum
    Advertisements
     

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Powered by vBadvanced CMPS v4.1.2